Vaccari Falco: Difference between revisions

Jump to navigation Jump to search
m (Transnapastain moved page Areiva Cuervo to Vaccari Falco)
(No difference)

Revision as of 17:47, 10 November 2020

Areiva Cuervo
AntigelOrel.jpg
TypeSurface-to-air missile
Place of origin Temuair
Service history
In service1953 - 1975
Used byImperial Air Force of Temuair
Production history
Designed1946 - 1953
ManufacturerAreiva
Produced1953 - 1960
VariantsAreiva Tridente
Specifications
Weight400 kg (880 lbs)
Diameter40 cm (15 in)
Warhead20 kg (44 lb) high-explosive

Wingspan140 cm (55 in)
Operational
range
20 km (12.5 miles)
Flight ceiling20000 m (66000 ft)
SpeedMach 1.8
Guidance
system
Beam riding

The Areiva Cuervo was one of the first surface to air missile systems developed, with Aisling based Areiva beginning design for the missile in 1946. It was used by the Armed Forces of the Temuair Empire, most notably the Imperial Air Force of Temuair from 1953 through 1975, when it was replaced by an upgraded version, the Areiva Tridente.

History

As aviation technology progressed, see the introduction of high altitude bombers and jet aircraft and their became more common in national air forces, most of the worlds military strategists concluded that anti-aircraft artillery was practically useless against high-flying targets, and would become completely so with the introduction of jet engines. Several nation, including Temuair, began guided missile efforts to fill this role, hoping to replace heavy anti-aircraft artillery.

The Cuervo went through a rapid development phase, and was upgraded several time sin rapid succession during its service life. It was accepted into service in 1953, and was offered for commercial export starting with the Cuervo-C, also known as the Areiva Tridente, model in 1958.

Design

The Areiva Cuervo was long, thin missile with a very high fineness ratio, similar to modern supersonic aircraft. It mounted four almost rectangular cropped-delta wings at the fuselage midpoint, and used thrust vectoring for directional control. Power was provided by a liquid fuel rocket engine burning nitric acid and kerosene as fuel, with the fuel driven into the engine via nitrogen gas pressurization.

Guidance was provided by a radar system and beam riding receivers on the missile. Beam riding systems are the simplest systems to implement, as the ground-based system can consist solely of a tracking radar. The target is first picked up on the radar system and "locked on". The missile is launched directly into the path of the radar, allowing receivers at the back of the missile to hear the radar signal and keep itself centered in the beam. The missile then flies directly at the target as long as the radar remains locked on. One disadvantage of this approach is that the radar signal is cone-shaped, so the missile becomes increasingly inaccurate as it flies away from the radar. The Cuervo solved this by using a second radio signal for beam riding, allowing the tracking radar to have a wider search angle without effecting the accuracy of the missile. Another disadvantage of any beam riding system is that it is not possible to "lead" the target, and it is thus suitable only for slow targets or very short distances.

The entire launcher system was based on two carriages adapted from heavy antiaircraft artillery pieces being retied from service. One carriage held the radar and guidance radio antenna on a rotating mount, and the other held the missile in a trapeze-like framework of some complexity. Follow-on versions used similar guidance systems, and varied more widely in the mounting of the missile. Dual mountings were common, and the launchers were generally much less complex than the original Cuervo version. Mounted on the trailer-base, the target tracking and illumination radar has a three-axis alignment system for the tracking antenna and the guiding beacon, it can precisely track overhead targets. The missile guides itself to the center of guiding beam. It was manufactured by Areiva Electronics.

Operational history

Operators

Former