Halvard I Class

Revision as of 11:18, 16 November 2022 by Licana (talk | contribs) (→‎1983 Refit)
Jump to navigation Jump to search
Halvard I.jpg
The Halvard I shortly after being recommissioned
Class overview
Operators: Trinovantum
Preceded by: Halvard IV Class
Succeeded by: None
Completed: 2
Active: 0
Lost: 1
Preserved: 1
General characteristics
Type: fast battleship
Displacement: 50,350 tonnes
Length: 248.2 meters
Beam: 32.9 meters
Draught: 11 meters
Propulsion: 8x three drum boilers, 130,000 shp (97,000 kW)
Speed: 30 knots
Range: 15,000 km at 15 knots
Complement: 1975
Sensors and
processing systems:
  • As built
  • MaRdSø-20 Early Warning Radar
  • MaRdSø-17 Air Search Radar
  • MaRdSø-12 Surface Search Radar
  • 2x MaRdRe-14 380 mm gun fire control Radar
  • 4x MaRdRe-9 133 mm dual-purpose gun fire control Radar
  • 10x MaRdRe-21 40mm anti-aircraft gun fire control Radar
  • 1983 refit
  • MaRdSø-61 Air Search Radar
  • MaRdSø-68 Surface Search Radar
  • 2x MaRdRe-14 380 mm gun fire control Radar
  • 2x MaRdRe-71 point-defense missile fire control system
  • MaKoMt-35 electronic warfare suite
Armament:
  • As built
  • 4x twin 380 mm MkII gun turret
  • 8x twin 133 mm MkIF dual purpose gun turret
  • 10x sextuple, 12x single 40mm anti-aircraft gun mounts
  • 1983 refit
  • 4x twin 380 mm MkII gun turret
  • 2x quadruple GMaVa-36 cruise missile box launcher
  • 4x quadruple GMaSø-29 antiship missile box launcher
  • 4x sextuple GMaRø-31 point-defense missile box launcher
  • 4x MaMkRø-76 30mm CIWS
Armour: 356mm - 50mm
Aircraft carried:

As Built: None

1983 refit: 4x UAV

The Halvard I Class battleships were a pair of fast battleships built for the Trinovantan Navy to replace the outdated Halvard IV Class fast battleships built in the 1910s-20s. Two ships were built out of the planned four, the Halvard I Håkonsson and the Karsten Askeladd. The Halvard I class ships were the largest and most advanced battleships produced in Trinovantum. They were also the final class of battleships to be produced in Trinovantum and part of the final generation of battleship designs.

Both ships saw combat during the Fourth Ostlander-Trinovantan War and the Fifth Ostlander-Trinovantan War. The Halvard I Håkonsson played a key roll in Operation Albatross which resulted in the end of the Fourth Ostlander-Trinovantan War and the Karsten Askeladd participated in the Omandan Continental War as part of the Allied fleet from 1984 until it was sunk in 1992.

Development

After the Third Ostlander-Trinovantan War, Trinovantan capital ship production was redirected to focus on aircraft carriers. These vessels had proved their value during the war, demonstrating a capability to severely damage and even destroy capital ships without ever being put in danger themselves. However, after over a decade of neglect, the Trinovantan battleship fleet was in danger of becoming seriously obsolete. While still possessing more of these capital ships than their primary rival, Ostlichtor, the majority of these ships predated the Third Ostlander-Trinovantan War.

With the fleet’s focus shifting to aircraft carriers, most of which could travel at speeds in excess of 30 knots, only the three remaining Halvard IV class fast battleships and the two severely outdated Aleksander II class battlecruisers could keep pace with modern aircraft carriers. The only modern battleship in the fleet at the time, the Magnus V, was only capable of 23 knots. With Ostlichtor confirmed to be building a new generation of modern fast battleships, the Trinovantan Navy put out a requirement for a new design of fast battleship capable of replacing the Halvard IV class.

Design

General Characteristics

At the time of its construction, the Halvard I class was one of the largest and highest displacement ships in the Trinovantan Navy. Though shorter in length than the preceding Halvard IV class ships, they had a larger beam and draught. With a displacement of 50,350 tonnes, they were also the heaviest warships commissioned by the Trinovantan Navy until the Ukuelig class aircraft carriers built in the 1970s.

Intended to serve as flagships for the two mainland fleets, the Halvard I ships had a normal complement of 115 officers and 1860 men as built. To facilitate this capacity, both ships were outfitted with an extensive centralized Combat Information Center to track friendly and hostile ships and aircraft in the vicinity around the ship. The ship used asbestos insulation in its construction, and key areas were given climate control in the form of air conditioning and steam heating to ensure the vessels could operate equally well in arctic or equatorial regions.

Armament

An example of the sextuple Gullspång 40mm Anti-aircraft gun mount designed for the Halvard I class

The primary armament of the Halvard I class was eight 380mm L/42 naval rifles in four twin gun turrets. These turrets could elevate from 0 to 30 degrees and were hydraulically powered. The guns were loaded at 5 degrees of elevation, a process that could be completed in under 30 seconds. They fired a heavyweight 880 kilogram projectile at a muzzle velocity of 749 m/s. At max elevation, these projectiles could range out to just over 30 km. With supercharges, this range increased to 35 km. 100 rounds of ammunition was provided for each gun, for a total of 800 rounds.

As a departure from previous Trinovantan designs, the Halvard I class did away with the 152mm secondary armament of its predecessors in favor of 133mm quick firing dual-purpose guns. 16 of these guns were mounted in two sets of four twin gun turrets. Capable of firing a 36.3 kilogram High Explosive, Proximity Fuze shell at a velocity of 814 m/s, at optimal elevation the range of these shells was 22 km. At max elevation, it was capable of striking aircraft flying at altitudes as high as 14 km. The turrets could be set to automatically track and elevate onto targets designated by the ship’s onboard RADAR. These guns were automatically loaded and capable of a rate of fire of 18 rounds per minute. 391 rounds were carried per gun, for a total ammunition load of 6,256.

Short range anti-aircraft defense was provided by 72 of Svenska’s Gullspång 40mm L/60 anti-aircraft guns. The majority of these guns were concentrated in 10 specifically designed sextuple mounts along the superstructure and stern. The remaining 12 guns were placed as powered single mounts on the upper deck and rear superstructure. These guns had a rate of fire of approximately 120 rounds per minute. All mounts were capable of elevating to 90 degrees and depressing to -10 degrees. The ships carried 1,269 rounds per gun.

Protection

The Halvard I class was the second class of Trinovantan designed ship to use an all or nothing armor scheme, which prioritized the protection and integrity of critical areas of the ship at the expense of outboard secondary areas. The main waterline belt armor consisted of 330mm of face-hardened cemented steel, increasing to 356mm abreast of the magazines and tapering down to a minimum of 114mm near the bottom of the hull. 305mm bulkheads protected access to the armored citadel of the ships. An additional 100mm bulkhead protected the aft steering gear room, and 38mm non-cemented armor bulkheads were provided to the magazines to prevent splinter damage from plunging fire.

The 380mm gun turrets featured 330mm of face hardened cemented steel at the fore, with the sides tapering from 230mm to 180mm. The top of the turrets are protected by 152mm of non-cemented steel. The armored barbettes featured 330mm thick steel at the sides that tapered to 280mm closer to the centerline. The secondary 133mm guns were protected by 64mm thick armor plates that increased to up to 152mm thickness around the ammunition feeds.

The deck featured a maximum of 152mm of non-cemented armor over the magazine, and 125mm of armor over the machine spaces. Beyond those, the deck armor tapered in incremental steps down to a minimum of 60mm at the bow. The aft deck armor also tapered to a minimum of 60mm at the stern, however the steering gear and propeller shafts were protected by a 115mm armor plate. This gave the critical areas of the Halvard I class ships protection against 500 kg armor piercing bombs when dropped from level altitudes of up to 4000 meters.

The armor on the conning tower was relatively light, being only 76mm for the primary tower and 50mm for the secondary tower. Underwater protection was provided by 3 layers of empty and liquid filled compartments designed to mitigate the shock of underwater detonations. The final underwater protection layer consists of a 40mm torpedo bulkhead. This system of underwater protection was proof against 450 kg of TNT detonated underwater along the citadel.

Propulsion

The Halvard I class featured 4 geared steam turbines, each in their own separate engine room. The turbines received power from 8 three drum boilers, also separated into four boiler rooms. These boilers operated at 2400 kPa and 370 °C. Each turbine drove a 3 blade, 4.5 meter diameter propeller. The combined output of this system was rated for 130,000 shaft horsepower for a top speed of 30 knots, though it demonstrated an output of 136,000 shp and a speed of 31.5 knots during early trials.

The Halvard Is were provided with 4930 t of fuel oil and 434 t of diesel fuel. At a sustained speed of 15 knots, these ships could travel for 15,280 km. Electrical power was provided by four 480 kW turbogenerators and four 450 kW diesel generators, both supplying the common ring at 220 V. The total output of these systems was 3,720 kW, far greater than any previous battleship commissioned in the Trinovantan Navy.

Sensors and Systems

To facilitate the ships intended role as flagship vessels, the Halvard I class was equipped with the best sensor and fire control equipment available at the time. It was the first vessel to feature the MaRdSø-20 early warning RADAR. Operating in the VHF band, the MaRdSø-20 was capable of detecting airborne targets at a range of approximately 320 km and surface targets at a range of approximately 35 km. For short range search and tracking, the Halvard I used the MaRdSø-12 surface tracking RADAR and the related MaRdSø-17 air tracking RADAR. Both systems operated in the S band, and provided more accurate tracking information than the long range MaRdSø-20.

For fire control, the ships featured a centralized MaDbRe-14 Fire Control Table for their 380mm naval rifles. The fire control table on the Halvard Is was significantly improved from the ones featured on its predecessor vessels, directly incorporating information from new RADAR equipped director towers for the main guns. The main armament could also be remotely directed onto targets from the FCT.

Centralized anti-aircraft fire control was handled by the MaDbRe-9 Secondary Fire Table. This was a dedicated control system for the secondary 133mm dual purpose guns, loosely derived from the older MaDbRe-2 Anti-Aircraft Fire Table. Unlike the older AAFT, the SFT could plot firing solutions for surface targets in addition to air targets. Like the MaDbRe-14 FCT, the SFT incorporates information from RADAR equipped director towers for enhanced accuracy. To further bolster the ship’s anti-aircraft capabilities, each of the 10 sextuple Gullspång 40mm gun mounts is equipped with their own RADAR fire director.

1983 Refit

After the surrender of Ostlichtor in the Fifth Ostlander-Trinovantan War, both ships were put into port for extensive refits to prepare for participation in the Omandan Continental War. Major changes were made to the superstructure of the ships, and their secondary armaments were entirely stripped to make room for new missile-based armaments. The RADAR and command and control systems were upgraded to modern standards to make use of these new systems, though the original analog fire control for the main cannons was retained.

The addition of long range land attack cruise missile and anti-ship missile armored box launchers was given to aid in the ship’s shore bombardment and surface control roles. To counter the threat of anti-ship missiles, the dual purpose secondary guns and anti-aircraft guns were replaced with a combination of modern missile and gun point defense systems, as well as multiple anti-missile chaff and decoy dispensers.

Facilities for carrying and operating a small number of reconnaissance and spotter UAVs were also added to the ship. Up to four could be carried by the ship, where they could be launched via a discarding rocket booster from the stern. These UAVs were recovered via a net that would be drug behind the ship.

Ships in Class

Hull
number
Name Laid down Launched Commissioned Fate
023 TRN Halvard I Håkonsson 5 March 1942 12 July 1945 28 September 1947 Decomissioned in 1990, preserved as a museum ship
024 TRN Karsten Askeladd 19 July 1945 24 October 1947 Sunk in 1992 during the Omandan Continental War

Service History