PaPø-35

Revision as of 06:47, 8 November 2019 by Licana (talk | contribs) (→‎Armament)
Jump to navigation Jump to search
TAL-35
TAL-35.jpg
TypeAirborne Tank Destroyer
Place of origin Trinovantum
Service history
Used by Trinovantum
Production history
DesignerGlobal Defense Land Systems
Designed1990-1994
ManufacturerGlobal Defense Land Systems
Produced2004-Present
Specifications
Weight20.1 tonnes (22.2 short tons; 19.8 long tons)
Length6.2 metres (20 ft 4 in)
Width2.69 metres (8 ft 10 in)
Height2.37 metres (7 ft 9 in)
Crew3 (commander, gunner, driver)

ArmorWelded Aluminium
Main
armament
12 x Global Defense Aerospace GMS-52 Hypersonic Anti-Tank missiles
Secondary
armament
1 x CAM-74 machine gun
Engine9.0L V6 turbo-diesel engine
552 hp
Power/weight28 hp/tonne
Suspensiontorsion bar
Ground clearance410 millimetres (1 ft 4 in)
Fuel capacity570 L (150 US gal)
Operational
range
483 km (300 mi)
Speed70 km/h (43 mph)

The TAL-35 is a Trinovantan air-deployable Anti-tank missile carrier developed by Global Defense Land Systems to augment the anti-armor capabilities of Trinovantan rapid deployment forces. It uses the same chassis as the TAG-35 airborne tank and carries the unconventional GMS-52 kinetic Anti-Tank Guided Missile as its primary weapon.

Development

The development of third generation main battle tanks the during the 1980s was expected to degrade the effectiveness of currently in-service anti-tank missiles to an unacceptable degree. At this time the best and primary means of neutralizing hostile armored threats available to the Trinovantan rapid deployment forces was the ATAL-24 ATGM carrier. The current Trinovantan TAG-33 had already demonstrated an exceptional resistance to current anti-tank missile systems, including the ATAL-24. Modern foreign designs such as the Notreceauen AVS 54 and the Dnieguin Tarskvagn-124 were believed to be similarly resistant to anti-tank missile threats. The expected proliferation of these vehicles, or other MBTs with similar capabilities, would thereby pose a significant risk to Trinovantan rapid deployment forces.

To address these concerns, a competition for a new anti-tank weapons system was initiated in 1987 to replace the ATAL-24. Requirements were simple; the weapon had to be able to defeat the armor of any current armored vehicle, it had to be capable of being paired to a airdrop capable vehicle, and it had to have a per-unit production cost that did not exceed 5 times the current cost of the GMS-23 missile used on the ATAL-24. Several designs were submitted, using various methods to achieve the criteria set out by the competition such as large tandem HEAT warheads or top-attack flight profiles. However, the Global Defense Aerospace proposal utilized a novel approach, a hardened steel penetrator mated to a high-output rocket. This weapon system, mounted on a new turret designed for Global Defense's recently developed TAG-35 airborne tank, would go on to win the program.

Armament

Live fire test of the GMS-52

The primary armament for the TAL-35 is Global Defense Aerospace's GMS-52 Hypersonic Anti-Tank missile. Instead of carrying a shaped charge like most contemporary ATGMs, the GMS-52's kill mechanism is a nearly two meter long high-hardness steel penetrator. As a result of this payload, the missile is significantly larger than most other ATGMs with a 162 millimeter diameter and a 2.8 meter overall length. The entire system weighs in excess of 80 kilograms. Guidance is provided via a simple laser seeker for semi-active laser homing. Propulsion is provided by a high-output solid fuel rocket fitted with a thrust vectoring nozzle for flight control. This rocket is capable of propelling the missile up to a maximum speed of 1500 meters per second in less than a second. The GMS-52 reaches its maximum range of 5000 meters four seconds after being fired.

When travelling at its maximum speed the missile has a kinetic energy of 90 Megajoules, which is approximately 8 times greater than the muzzle energy of a modern APFSDS penetrator fired by a main battle tank. During testing, the GMS-52 demonstrated that it was capable of inflicting catastrophic damage to the most heavily armored vehicles in the Trinovantan military's inventory. It is projected to be capable of destroying any current or near-future armored threat. The TAL-35 does not carry more than the 12 missiles contained within the turret. Extra ammunition for reloading must be transported in a separate vehicle. While reloading by hand is possible, due to the size and weight of the GMS-52 missile and the height of the turret it is recommended that a loading crane is used to reload the vehicle.

For defense against infantry and light vehicular threats, the TAL-35 mounts a single CAM-74 heavy machine gun above the turret.

Protection

As per the TAG-35, the TAL-35's is protected by lightweight aluminum armor. The high hardness steel plates reinforcing the TAG-35 have been stripped in order to keep the weight of the vehicle within acceptable air-dropping tolerances. Similarly, the turret of the TAL-35 is primarily constructed out of aluminium. This gives the TAL-35 protection against most anti-material rifles from the front and sides. In the event of a penetration into the fighting compartment of the vehicle, several countermeasures are in place to mitigate damage. A modern spall liner is installed along the interior of the vehicle to reduce spall fragmentation from armor perforation and an automatic fire extinguisher is present in the engine bay. The vehicle also features an overpressure system to protect the crew from CBRN threats.

Mobility

The TAL-35's powertrain consists of a Paxton Heavy Industries 9.0 Liter V6 Turbo diesel producing 412 kW (552 hp) at 2300 rpm and 1400 NM (1030 ft-lb) at 1500 rpm mated to a UE 4 speed (3 forward, 1 reverse) variable-ratio hydromechanical transmission, which is capable of propelling the vehicle up to an electronically limited to speed of 72 km/h (45 mph). The transmission also incorporates hydromechanical steering and dynamic braking, with a manually actuated service brake also integrated into the transmission unit. A rear hull ramp is present on the TAL-35 that folds down to directly access the engine compartment. The entire powerpack can be disconnected and slid onto the ramp without specialized tools.

The TAL-35 uses a simple torsion bar suspension. Hydraulic shock absorbers are installed at each of the six road wheel stations in order to improve cross-country mobility and firing stability. The suspension has a maximum object clearance of 760mm (30 in), with a trench clearance of 2100 mm (83 in). It is capable of traversing slopes of a grade up to 60 degrees, or side-slopes to up 40 degrees. Bodies of water up to 1300 mm (52 in) deep can be forded without significant preparation.

Due to its light weight and relatively compact size, the TAL-35 can be carried and delivered by most military airlift transport aircraft. As an airborne vehicle, the TAL-35 can be rapidly deployed via low-altitude parachute-extraction in situations where conventional airlifting methods are either impossible or otherwise not preferable. This type of deployment requires specialized shock-absorbing pallets and a potentially hazardous low-speed and low-altitude approach to the deployment zone. When deployed in this manner, the crew of the TAL-35 must be deployed separately from the vehicle.

Sensors and Systems

Operational History

Operators

Current

See Also