BSCh-7

Revision as of 23:25, 11 March 2019 by Soode (talk | contribs) (Created page with "{{infobox weapon | name = BSCh-7 | image = 300px | caption = Main Army variants of the BSCh-7, wit...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
BSCh-7
File:BSCh-7.png
Main Army variants of the BSCh-7, with cross-section view
TypeArmored Personnel Carrier
Place of origin Menghe
Service history
In service1996-present
Used by Menghe
Production history
DesignerTaekchŏn armored vehicle design bureau
Designed1992-1995
ManufacturerYŏng'an April 17th Factory
Songrimsŏng Military Automotive Plant
Unit cost$650,000
Produced1996-present
No. built27,000
Specifications (BSCh-7B)
Weight16.8 tonnes
Length8.04 m
Width2.8 m
Height2.55 m
Crew2 (driver, gunner)
Passengers10 + 1

Armorwelded steel plate
Main
armament
12.7mm JG-77 heavy machine gun
EngineKa-1212
360 kW (480 horsepower)
Power/weight28.6 hp/tonne
Suspensionwheeled 8x8
Ground clearance45 cm
Operational
range
800 km (internal fuel)
SpeedLevel road: 90 km/h
Swimming: 8 km/h

The BSCh-7 (Menghean: 분대 수송 장갑차, Budae Susong Janggabcha, lit. "Squad Transporting Armored car") is an armored personnel carrier designed in the Socialist Republic of Menghe as a replacement for the '70s-vintage BunSuCha-4. It features an improved internal layout and better protection against explosive threats, as well as an eight-wheel suspension with a lower center of gravity for better offroad mobility. Though still too lightly armored to serve as an infantry fighting vehicle, it is still more capable than the "battle taxi" BSCh-4. With some 27,000 vehicles produced, it has replaced the BSCh-4 in all active units and most Mobilization Reserve formations.

Design

Layout

Unlike its predecessor, the BSCh-4, the BSCh-7 has its engine located between the driver's area and the passenger compartment, with the transported squad disembarking through a large ramp-door in the rear. The hatches in the middle of the hull are retained as a backup option, though they are located on the upper half of the vehicle. The passengers are seated facing outward, with the engine's driveshaft running downward between the rows of seats and the space above used for storage. There are ten firing ports on the vehicle: three on either hull side, two on the rear ramp, and one on each forward side door. Passengers can also fire by standing in the top hatches or opening the side hatches.

The front of the vehicle is taken up by the crew compartment, in which the driver is seated on the left and the eleventh passenger (either the unit commander, the platoon NCO, or the marksman in a standard motorized platoon) is seated on the right. The turret, which has a one-man crew in all variants, is centered directly behind them, with ammunition stored below. The engine is located in the center of the vehicle, allowing the passengers to disembark without breaching the forward area's airtight CBRN seal.

Armament

Main armament on the BSCh-7A and -7B consists of a single 12.7mm JG-77 heavy machine-gun mounted in a fully enclosed turret. The gunner is provided with a hatch in the turret roof for surveillance or rapid escape, and a forward periscope for aiming. Other variants, described below, add different armament options, but the 12.7mm turret is the most common in Army service.

Protection

The BSCh-7's armor has the claimed capability to withstand 12.7mm armor-piercing ammunition across the 60-degree frontal arc at combat ranges. The sides and rear are protected against small-arms fire and shrapnel. Applique armor plates or slat-armor arrays can be fitted to the front and sides, though the heavier kits degrade amphibious capability. The vehicle can be CBRN-sealed if necessary, with a filtration system supplying overpressure air to the crew and passenger compartments. The air filtration and ventilation system also reduces the buildup of gunsmoke in the passenger compartment when the firing ports are in use. The underside of the hull has an angled V-shape to deflect the blast from mines, and both crew and passenger seats are attached to the wall or roof in order to further insulate against blast shock.

Mobility

The first variant, accepted into service as the BSCh-7A, was equipped with an old-model 205-kW (275-horsepower) engine. After repeated complaints about poor speed and mobility, especially when climbing rough terrain, this was replaced by a more modern 360-kW engine in the BSCh-7B. This variant can reach 95 kilometers per hour on flat roads, though speed is significantly reduced in rough terrain, especially muddy areas. All eight wheels are powered, and propulsion in water is provided by a pair of enclosed propellers on either side of the hull rear, which can bring the vehicle to 8 kilometers per hour when "swimming." This variant became standard in new production after 2001.

All BSCh-7 variants have a centralized tire pressure control system, allowing the driver to adjust tension depending on the terrain type. The tires are semi-protected, and have a "run-flat" system to allow the vehicle to continue operating for a limited time after one of the tires has been punctured.

Variants

BSCh-7Ch

The BSCh-7Ch, also known as the BSCh-7HB (Haegun Bobyŏng, Marine Infantry}}, was originally produced in response to a 2003 request by the Marine Infantry for a heavily armed vehicle which could assault hostile beaches. It has a larger turret with a 22mm autocannon, also aimed by a single gunner. There is no dedicated commander in the vehicle, though the sergeant may ride alongside the driver while the platoon headquarters and marksman are seated in the passenger compartment. Despite some initial interest, the BSCh-7Ch soon lost popularity in the Menghean Army's procurement department due to its poor commander layout and a feeling that the 22mm autocannon stood on poor middle ground between 12.7mm and 32mm weapons.

BSCh-7D

Built on the same up-engined chassis as the BSCh-7B, the -D grew out of the same request that produced the -7Ch. It uses a turret similar to that on the BunSuCha-4Ch, with a 38mm automatic grenade launcher on the right and a 7.62mm machine-gun on the left. Like the BSCh-4Ch, it was not ordered in large numbers, and is mainly issued to Gunchal brigades and divisional troops, who would be tasked with patrolling rear areas against enemy special forces or insurgents.

BSCh-7E

File:BSCh-7E Ummayah.png
BSCh-7E exported to Ummayah, in local paint scheme.

Advertised as a wheeled IFV, the BSCh-7E features the turret from the BSCh-5 mounted over the passenger compartment. This reduces the rear passenger capacity to six, with two more seated beneath where the original turret was located. Ummayah placed a small order in 2013, but the Menghean Army has shown little interest in the vehicle, which is thinly armored and top-heavy.

Other Variants

File:BSCh-7 RRB.png
BSCh-7 variants used by the Rapid Response Brigades.
  • JJYB-120: An armored, self-propelled mortar carrier (Janggab-Jaju-Yudan-Balsagi) intended for Battalion fire support. The top of the rear hull is built with a large two-door hatch, allowing the crew to operate a 120mm mortar from the passenger compartment. Fire-control is performed by the commander, seated beside the driver, while two additional crew operate the mortar in its separate compartment. The 12.7mm HMG turret of the original BSCh-7B is retained, and can be operated by the commander if the vehicle comes under attack.
  • BSCh-7DS: Battalion command vehicle (Daedae Salyŏngcha). It has a distinctive raised cabin with front and side windows over the troop compartment, providing space for the command staff to stand. It also carries an open machine-gun cupola instead of an enclosed turret.
  • BSCh-7JG: Armored ambulance (Janggab Gugŭbcha) typically used at the Battalion level to evacuate wounded soldiers to a battalion medical point or higher. It has the same internal capacity as the BSCh-7JG, but loading stretchers via the rear ramp is easier, and it has better protection and offroad capability.
  • BSCh-7NAA: Variant for the Rapid Response Brigades of the Internal Security Forces, the BSCh-7NAA is based on the BSCh-7B's chassis but uses a smaller turret with a 7.62mm GPMG.
  • BSCh-7NAB: Modified BSCh-7NAA in which the GPMG is replaced with a manually operated, breech-loading grenade launcher. Unlike Menghean automatic grenade launchers, it uses the 42mm caliber common on under-barrel grenade launchers. In service it would primarily be used to launch tear gas grenades over crowds.

Users